Larue County, KY
Home inspections in Hodgenville, Kentucky.
We have inspected 73 homes in Hodgenville. The median one was built in 1984, runs 1,740 square feet, and 53% of them have a basement. Here is what that means for the house you are under contract on.
Those four numbers come from the 73 homes we have actually inspected in Hodgenville, not from a national average. They are the reason a Hodgenville inspection reads differently from one twenty minutes down the road.
Hodgenville sits about 11 miles southeast of Elizabethtown, in Larue County — it is the county seat. We inspect here constantly, there is no trip charge, and you get the same electronic report with a photograph of every finding that we hand a buyer anywhere else.
Glendale is our nearest coverage to Hodgenville, and the two are not interchangeable. The housing stock is older — a median build year of 1984 here against 1998 there, 14 years apart.
What Hodgenville homes are built on
Share of the Hodgenville homes in our records by foundation type. Foundation drives the inspection: it decides where water goes, where the ductwork runs, what we can see and what we have to infer.
Pre-1978 homes and the disclosure that comes with them
44% of the Hodgenville homes we have inspected pre-date 1978, which is the federal cutoff for lead-based paint. On any house built before that year the seller has to give you the EPA lead disclosure and a ten-day window to have a lead risk assessment done if you want one. A standard home inspection is not a lead test — we will flag deteriorated painted surfaces on an older Hodgenville house, but a paint-chip or dust-wipe assessment is a separate specialist scope, and it is worth doing if you have small children.
The other thing that comes with that vintage in this area is the electrical panel. Homes from the 1950s and 60s were built for a fraction of today's load, and a lot of them are running on a service that has been added to rather than replaced.
Supply piping: what era the house was plumbed in
About 25% of Hodgenville homes in our records fall in the 1978–1995 build window, which is when polybutylene supply piping was in common use. That gray or blue flexible plastic degrades from the inside where chlorinated water touches it, so age tells you more than appearance does. We check the water heater connections, the main shutoff and any exposed runs in the crawlspace or basement, and we say plainly in the report which material the house is plumbed in.
If the house has already been repiped to PEX or copper, that is a real value item and it belongs in the report. If it has not, call your insurance agent during the inspection period rather than after — coverage on active polybutylene is not automatic.
Crawlspaces: 42% of the homes here sit on one
Crawlspace is the most common foundation type in Hodgenville — 42% of the homes in our records — and it is where most of the findings on a Hodgenville inspection come from. We go in. Standing at the access door with a flashlight tells you nothing about the far corner.
What we are reading down there is moisture history: a torn or missing vapor barrier, standing water or silt lines on the piers, efflorescence on block, rust on the duct straps, and fungal growth on the joists and subfloor. Wood does not have to be wet to be damaged; it has to have been wet.
The two repairs we recommend most are also the two cheapest: get the downspouts discharging six to ten feet from the foundation, and get a continuous vapor barrier over the entire soil surface with the seams lapped. Encapsulation and a dehumidifier are the right answer for some houses, but a lot of crawlspaces in this area are wet for reasons that start at the gutters.
Roof covering: what we can tell you and what we cannot
Roof age is the question we get asked on every Hodgenville inspection, and the honest answer is that nobody can read a remaining service life off a shingle. What we can do is tell you what is up there and what condition it is in. Three-tab asphalt is a thinner, flatter shingle with cutouts; architectural or dimensional asphalt is thicker and layered. Both are commonly rated in the 20-to-30-year range, and both reach the end of that range faster on a south-facing slope with poor attic ventilation cooking them from below.
The specific things we report are granule loss and exposed mat, curled or cupped tabs, cracked or missing shingles, nail pops, condition of the flashing at every penetration and roof-to-wall intersection, whether there is a drip edge, and whether a second layer was installed over the first. That last one matters: a layover hides the deck, shortens the life of the new covering, and turns the next re-roof into a tear-off of two layers rather than one.
On metal roofs the wear item is almost never the panel. It is the fastener — specifically the rubber grommet under the screw head, which hardens and shrinks with UV exposure and thermal cycling long before the steel gives out. Exposed-fastener metal roofs need those screws checked and periodically replaced, and a roof that has never had that done is a maintenance item whatever the panel looks like.
HVAC: the data plate tells you more than the thermostat
We start at the data plate. Serial numbers date the equipment, and age is the most useful single number you can have about an HVAC system. Gas furnaces commonly run fifteen to twenty-five years, air conditioners and heat pumps twelve to eighteen. A system that runs perfectly on inspection day and is nineteen years old is a budgeting item, and it should be in your head before you negotiate.
Heat pumps are common in this area and they are also the system buyers most often misunderstand. A heat pump moves heat rather than making it, which is why the supply air feels cooler than a gas furnace's. Emergency or auxiliary heat is resistance heat strips, and it is expensive to run — a heat pump stuck in EM heat can double a winter bill without anything looking broken. We check that the changeover works and that EM heat is not simply running.
Geothermal shows up here as well, and it is a different animal: the loop field is buried and cannot be inspected visually, the desuperheater may be tied to the water heater, and service is a specialist trade rather than a general HVAC call. If the house has a geothermal system, we report what is visible at the equipment and recommend records from the installing contractor.
Radon testing in Hodgenville
The EPA places Larue County in Radon Zone 2, which predicts a county average indoor screening level between 2 and 4 picocuries per liter — below the 4 pCi/L action level, but not low.
Zone 2 is the tier where people most often talk themselves out of testing, and it is the tier where we most often find that they should not have. The map predicts a county average. Radon is a soil gas, it enters through the particular cracks, sumps and penetrations in one particular foundation, and houses a hundred yards apart in Hodgenville can and do test on opposite sides of the action level. The only way to know a number for the house you are buying is to test the house you are buying.
We run radon testing for $150 when it is added to the same visit as the home inspection. The device sits in the lowest livable level under closed-house conditions, and you get the result with your report.
What it costs in Hodgenville
The median Hodgenville home in our records is 1,740 square feet, which puts a typical house here in the $500 tier. Quoted before you book, with no trip charge to Hodgenville. Veteran discount for anyone who has served — active duty, Guard, Reserve or retired. Full pricing.
Hodgenville inspection questions
How much does a home inspection cost in Hodgenville, KY?
A full home inspection is $500 for homes up to 1,999 square feet and $650 for homes from 2,000 to 3,500 square feet. Above 3,500 square feet we quote individually. Radon testing is $150 added to the same visit. The median Hodgenville home we inspect is 1,740 square feet. There is no trip charge to Hodgenville.
Do I need a radon test in Hodgenville?
The EPA places Larue County in Zone 2, where the predicted county average falls between 2 and 4 pCi/L. Zone maps predict county averages, not individual homes, which is why the EPA recommends testing the specific house. We test for $150 when it is scheduled with the inspection.
How long does a home inspection take in Hodgenville?
Plan on two to three hours on site for a typical Hodgenville home, and longer for larger houses or homes with multiple HVAC systems or outbuildings. You are welcome to be there. Your electronic report follows with photos of every finding.
Is polybutylene plumbing common in Hodgenville?
25% of the Hodgenville homes in our records were built between 1978 and 1995, the window when polybutylene supply piping was standard, so it is one of the first things we look for here. If we find it, contact your insurance agent before your inspection contingency expires — coverage on active polybutylene is not automatic.
We also inspect near Hodgenville
Every town we cover is listed on the service area page.
Ready when you are
Get the inspection on the calendar.
Under contract in Hodgenville with a deadline? Call or email and we will work around your timeline.